Permanent URI for this collection
Browsing Wireless Communication by Subject "group communication"
Now showing 1 - 3 of 3
Results Per Page
- ItemDiscovery and Group Communication for Constrained Internet of Things Devices using the Constrained Application Protocol(Ghent University, 2015) Ishaq, IsamThe ubiquitous Internet is rapidly spreading to new domains. This expansion of the Internet is comparable in scale to the spread of the Internet in the ’90s. The resulting Internet is now commonly referred to as the Internet of Things (IoT) and is expected to connect about 50 billion devices by the year 2020. This means that in just five years from the time of writing this PhD the number of interconnected devices will exceed the number of humans by sevenfold. It is further expected that the majority of these IoT devices will be resource constrained embedded devices such as sensors and actuators. Sensors collect information about the physical world and inject this information into the virtual world. Next processing and reasoning can occur and decisions can be taken to enact upon the physical world by injecting feedback to actuators. The integration of embedded devices into the Internet introduces new challenges, since many of the existing Internet technologies and protocols were not designed for this class of constrained devices. These devices are typically optimized for low cost and power consumption and thus have very limited power, memory, and processing resources and have long sleep periods. The networks formed by these embedded devices are also constrained and have different characteristics than those typical in todays Internet. These constrained networks have high packet loss, low throughput, frequent topology changes and small useful payload sizes. They are referred to as LLN. Therefore, it is in most cases unfeasible to run standard Internet protocols on this class of constrained devices and/or LLNs. New or adapted protocols that take into consideration the capabilities of the constrained devices and the characteristics of LLNs, are required. In the past few years, there were many efforts to enable the extension of the Internet technologies to constrained devices. Initially, most of these efforts were focusing on the networking layer. However, the expansion of the Internet in the 90s was not due to introducing new or better networking protocols. It was a result of introducing the World Wide Web (WWW), which made it easy to integrate services and applications. One of the essential technologies underpinning the WWW was the Hypertext Transfer Protocol (HTTP). Today, HTTP has become a key protocol in the realization of scalable web services building around the Representational State Transfer (REST) paradigm. The REST architectural style enables the realization of scalable and well-performing services using uniform and simple interfaces. The availability of an embedded counterpart of HTTP and the REST architecture could boost the uptake of the IoT. Therefore, more recently, work started to allow the integration of constrained devices in the Internet at the service level. The Internet Engineering Task Force (IETF) Constrained RESTful Environments (CoRE) working group has realized the REST architecture in a suitable form for the most constrained nodes and networks. To that end the Constrained Application Protocol (CoAP) was introduced, a specialized RESTful web transfer protocol for use with constrained networks and nodes. CoAP realizes a subset of the REST mechanisms offered by HTTP, but is optimized for Machine-to-Machine (M2M) applications. This PhD research builds upon CoAP to enable a better integration of constrained devices in the IoT and examines proposed CoAP solutions theoretically and experimentally proposing alternatives when appropriate. The first part of this PhD proposes a mechanism that facilitates the deployment of sensor networks and enables the discovery, end-to-end connectivity and service usage of newly deployed sensor nodes. The proposed approach makes use of CoAP and combines it with Domain Name System (DNS) in order to enable the use of userfriendly Fully Qualified Domain Names (FQDNs) for addressing sensor nodes. It includes the automatic discovery of sensors and sensor gateways and the translation of HTTP to CoAP, thus making the sensor resources globally discoverable and accessible from any Internet-connected client using either IPv6 addresses or DNS names both via HTTP or CoAP. As such, the proposed approach provides a feasible and flexible solution to achieve hierarchical self-organization with a minimum of pre-configuration. By doing so we minimize costly human interventions and eliminate the need for introducing new protocols dedicated for the discovery and organization of resources. This reduces both cost and the implementation footprint on the constrained devices. The second, larger, part of this PhD focuses on using CoAP to realize communication with groups of resources. In many IoT application domains, sensors or actuators need to be addressed as groups rather than individually, since individual resources might not be sufficient or useful. A simple example is that all lights in a room should go on or off as a result of the user toggling the light switch. As not all IoT applications may need group communication, the CoRE working group did not include it in the base CoAP specification. This way the base protocol is kept as efficient and as simple as possible so it would run on even the most constrained devices. Group communication and other features that might not be needed by all devices are standardized in a set of optional separate extensions. We first examined the proposed CoAP extension for group communication, which utilizes Internet Protocol version 6 (IPv6) multicasts. We highlight its strengths and weaknesses and propose our own complementary solution that uses unicast to realize group communication. Our solution offers capabilities beyond simple group communication. For example, we provide a validation mechanism that performs several checks on the group members, to make sure that combining them together is possible. We also allow the client to request that results of the individual members are processed before they are sent to the client. For example, the client can request to obtain only the maximum value of all individual members. Another important optional extension to CoAP allows clients to continuously observe resources by registering their interest in receiving notifications from CoAP servers once there are changes to the values of the observed resources. By using this publish/subscribe mechanism the client does not need to continuously poll the resource to find out whether it has changed its value. This typically leads to more efficient communication patterns that preserve valuable device and LLN resources. Unfortunately CoAP observe does not work together with the CoAP group communication extension, since the observe extension assumes unicast communication while the group communication extension only support multicast communication. In this PhD we propose to extend our own group communication solution to offer group observation capabilities. By combining group observation with group processing features, it becomes possible to notify the client only about certain changes to the observed group (e.g., the maximum value of all group members has changed). Acknowledging that the use of multicast as well as unicast has strengths and weaknesses we propose to extend our unicast based solution with certain multicast features. By doing so we try to combine the strengths of both approaches to obtain a better overall group communication that is flexible and that can be tailored according to the use case needs. Together, the proposed mechanisms represent a powerful and comprehensive solution to the challenging problem of group communication with constrained devices. We have evaluated the solutions proposed in this PhD extensively and in a variety of forms. Where possible, we have derived theoretical models and have conducted numerous simulations to validate them. We have also experimentally evaluated those solutions and compared them with other proposed solutions using a small demo box and later on two large scale wireless sensor testbeds and under different test conditions. The first testbed is located in a large, shielded room, which allows testing under controlled environments. The second testbed is located inside an operational office building and thus allows testing under normal operation conditions. Those tests revealed performance issues and some other problems. We have provided some solutions and suggestions for tackling those problems. Apart from the main contributions, two other relevant outcomes of this PhD are described in the appendices. In the first appendix we review the most important IETF standardization efforts related to the IoT and show that with the introduction of CoAP a complete set of standard protocols has become available to cover the complete networking stack and thus making the step from the IoT into the Web of Things (WoT). Using only standard protocols makes it possible to integrate devices from various vendors into one bigWoT accessible to humans and machines alike. In the second appendix, we provide an alternative solution for grouping constrained devices by using virtualization techniques. Our approach focuses on the objects, both resource-constrained and non-constrained, that need to cooperate by integrating them into a secured virtual network, named an Internet of Things Virtual Network or IoT-VN. Inside this IoT-VN full end-to-end communication can take place through the use of protocols that take the limitations of the most resource-constrained devices into account. We describe how this concept maps to several generic use cases and, as such, can constitute a valid alternative approach for supporting selected applications.
- ItemExperimental Evaluation of Unicast and Multicast CoAP Group Communication(MDPI, 2016-07-21) Ishaq, IsamThe Internet of Things (IoT) is expanding rapidly to new domains in which embedded devices play a key role and gradually outnumber traditionally-connected devices. These devices are often constrained in their resources and are thus unable to run standard Internet protocols. The Constrained Application Protocol (CoAP) is a new alternative standard protocol that implements the same principals as the Hypertext Transfer Protocol (HTTP), but is tailored towards constrained devices. In many IoT application domains, devices need to be addressed in groups in addition to being addressable individually. Two main approaches are currently being proposed in the IoT community for CoAP-based group communication. The main difference between the two approaches lies in the underlying communication type: multicast versus unicast. In this article, we experimentally evaluate those two approaches using two wireless sensor testbeds and under different test conditions. We highlight the pros and cons of each of them and propose combining these approaches in a hybrid solution to better suit certain use case requirements. Additionally, we provide a solution for multicast-based group membership management using CoAP.
- ItemFlexible Unicast-Based Group Communication for CoAP-Enabled Devices(Sensors, 2014-06-04) Ishaq, IsamSmart embedded objects will become an important part of what is called the Internet of Things. Applications often require concurrent interactions with several of these objects and their resources. Existing solutions have several limitations in terms of reliability, flexibility and manageability of such groups of objects. To overcome these limitations we propose an intermediately level of intelligence to easily manipulate a group of resources across multiple smart objects, building upon the Constrained Application Protocol (CoAP). We describe the design of our solution to create and manipulate a group of CoAP resources using a single client request. Furthermore we introduce the concept of profiles for the created groups. The use of profiles allows the client to specify in more detail how the group should behave. We have implemented our solution and demonstrate that it covers the complete group life-cycle, i.e., creation, validation, flexible usage and deletion. Finally, we quantitatively analyze the performance of our solution and compare it against multicast-based CoAP group communication. The results show that our solution improves reliability and flexibility with a trade-off in increased communication overhead.